SRAM RockShox Super Deluxe R Service Manual page 26

Install the seal head/air piston onto the damper shaft.
8
Clamp the damper shaft into the RockShox® Rear Shock Vise Block.
9
To prevent damage to the seal head/air piston, position the shaft in the
vise so that the piston and IFP reservoir are clear of the vise jaws.
Install the main piston assembly that was removed in step 5 onto the
10
damper shaft. Squeeze the shims and center the shim stack on top of
the main piston.
If desired, install a new piston tune. Refer to the RockShox spare parts
catalog on www.sram.com.
Be sure to keep the main piston assembly parts in the same order.
If the shims are not centered and in the correct order, the shock will not
perform properly.
Thread the nut onto the damper shaft. Tighten the main piston nut to
11
6.8 N•m (60 in-lb).
Remove the assembly from the vise.
NOTI CE
NOTI CE
12 mm 6.8 N•m (60 in-lb)
Piston Service 26