Table of Contents
Advertisement
2 0 0 H o u r S e r v i c e
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a rag. Apply grease to the new seal or o-ring. Only use RockShox®
Dynamic Seal Grease when servicing RockShox shocks.
To prevent damage to the shock use aluminum soft jaws and position
the eyelet in the vise so that the adjustment knobs are clear of the
vise jaws.
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
Clamp the shaft eyelet into the vise.
1
Use a Schrader valve tool to remove the IFP reservoir valve cap. Use a
small hex wrench or pick to depress the Schrader valve and release all
air pressure from the IFP reservoir.
Once the pressure has been released, depress the Schrader valve a
second time. If the Schrader valve is able to move, the shock has been
completely depressurized.
If the Schrader valve does not move at all, the shock is still
pressurized and will need to be sent to an authorized RockShox
service center for further service.
⚠ CAU T ION - EYE HA ZARD
Verify all pressure is removed from the shock before proceeding.
Failure to do so can cause the damper body to separate from the shaft
eyelet at a high velocity. Wear safety glasses.
Do not remove the damper body bleed screw from the damper body
eyelet until instructed to do so. Removing the damper body bleed
screw while the shock is pressurized will result in fluid being forcefully
ejected from the bleed port. Wear safety glasses.
Use a Schrader valve tool to remove the Schrader valve core from the
2
IFP reservoir valve.
Do not discard the Schrader valve core.
I F P R e s e r v o i r S e r v i c e
N OTICE
IFP Reservoir Service
19
Advertisement
Table of Contents
