Slowly pull up on the damper body until it stops. This will cycle fluid
12
from the reservoir back into the damper body and purge air bubbles
from the system.
Continue to pull up and push down on the damper body until no more
air bubbles emerge from the IFP bleed port.
Install the IFP bleed screw into the IFP. The bleed screw should be
13
submerged in fluid.
Remove the damper body bleed screw from the damper body eyelet.
14
Wrap a clean rag around the damper body. Slowly push down on
15
the damper body to purge the air bubbles from the bleed port in the
damper body eyelet.
Stop pushing on the damper body when there are no more air bubbles.
T10 TORX®
T10
Shock Assembly and Bleed
30