Shock Assembly And Bleed - SRAM RockShox Super Deluxe Service Manual

Thread the nut onto the damper shaft. Tighten the main piston nut to
12
6.8 N•m (60 in-lb).
Remove the assembly from the vise.
2 0 0 H o u r S e r v i c e
When replacing seals and o-rings, use your fingers or a pick to remove
the seal or o-ring. Spray isopropyl alcohol on each part and clean with
a rag. Apply grease to the new seal or o-ring. Only use RockShox®
Dynamic Seal Grease when servicing RockShox shocks.
To prevent damage to the shock use aluminum soft jaws and position
the eyelet in the vise so that the adjustment knobs are clear of the
vise jaws. For bearing mount shocks, wrap a rag around the eyelet,
then clamp the eyelet flat into the vise.
Inspect each part for scratches. Do not scratch any sealing surfaces
when servicing your suspension. Scratches can cause leaks.
RTR: Install the lock spring and lock shim into the reservoir mount.
1
S h o c k A s s e m b l y a n d B l e e d
NOTI CE
RTR

Shock Assembly and Bleed

12 mm 6.8 N•m (60 in-lb)
RTR
40