SOLTEK KT400-R Manual page 49

5. In the "Update device Driver Wizard" screen, click "Next" to continue
until you see a dialog box asking you to "Specify a location" for the
driver. You should now insert the Support CD into your CD-ROM.
6. As illustrated in the picture below, check the item "Specify a location"
and click the "Browse" button to find out the correct path for the
driver. Supposing your CD-ROM drive is Drive E, please type:
E:\Driver\Network\VIA6183 into the blank bar. (If you are
installing on Win 95OSR2, you should type W95OSR2 instead of
Win98.) Then click the "Next" button to continue.
7. The Update Device Driver Wizard will then go on installing the driver,
until the "Insert Disk" dialog box shows up. Please withdraw your
Support CD and insert the Win 98 CD-ROM into the CD-ROM drive
for updating system and click "OK" to continue.
8. The Update Device Driver Wizard will then proceed to update the
system with the LAN driver. When the "Finish" screen shows up,
click "Finish" to continue.
9. Final Dialog box will appear to remind you that you must restart your
computer to finish updating the new hardware. Please click "Yes" to
restart system and finish the LAN driver installation.
Enter the correct path for the
location of LAN driver
53
Chapter 3 Software Setup