SOLTEK KT400-R Manual page 65

KT400-R / KT400-RL
Configure SDRAM
Timing by SPD
SDRAM Frequency Allows you to set the SDRAM frequency.
SDRAM CAS# Latency With SDRAM Timing by SPD disabled, you can se-
SDRAM Bank Inter-
leave
SDRAM Burst Length With SDRAM Timing by SPD disabled, you can se-
SDRAM Command
Rate
Fast Command
AGP Mode Allows you to see the AGP Mode on board. The
AGP Fast Write Allows you to enable / disable the AGP Fast Write
SPD (Serial presence detect) is a device in memory
module for storing the module information such as
DRAM timing and chip parameters. If this option is
enabled, BIOS will access SPD automatically to
configure module timing. If disabled, DRAM timing
can be configured manually.
Choices: Auto; 200MHz; 266MHz; 333MHz; 400MHz
lect the SDRAM CAS# (Column Address Strode)la-
tency manually.
Choices: 2Clocks; 2.5 Clocks; 1.5 Clocks; 3.0 Clocks
This item allows you to enable / disable SDRAM
Bank Interleave function.
Choices: Disabled (default); 2-way; 4-way
lect the SDRAM Burst length manually.
Choices: 8; 4
Allows you to set the SDRAM Command Rate.
Choices: 1T; 2T
Allows you to select the Fast Command Mode.
Choices: Normal; Fast; Ultra
default setting is Auto. This item supports 4X/8X AGP
Mode. 2X and 1X modes are included in options for
attempt to lower the AGP speed.
function
70