Table of Contents
Advertisement
5-2.4-2 Installing Drivers With Existing Windows NT4.0
W A R N I N G :
W A R N I N G :
moving the boot drive containing the existing Windows 2000 operating
system on to the FastTrak 376 controller (e.g. IDE3/SATA1/SATA2).
On mainboard, IDE1/0 are for system IDE controller, while IDE3 &
SATA1/2 are under RAID controller.
With your bootable hare drive connected to IDE1/IDE2 and FastTrak 376
enabled in BIOS, boot Win NT4.0.
1. Choose "Settings" from the "Start" menu.
2. Choose "Controller Panel" from the "Settings" menu.
3. Double-click on the "SCSI Adapters" icon, which generates the
"SCSI Adapters" dialog box.
4. Choose "Drivers," and then press "Add."
5. In the "Install Drivers" dialog box, press "Have Disk..."
6. When the "Install From Disk" appears, insert into Drive A the "FastTrak
376 Driver" diskette that you have made from support CD:.
7. Type "A:\NT4" in the text box window, then choose "OK."
8. When the "Install Driver" dialog box appears, select " Win NT Prom
ise FastTrak 376 controller" and then press "OK."
9. When the "Select SCSI Adapter Option" dialog box appears, press "Install".
10. After a successful installation, the "SCSI Adapter Setup" box will show
that the "Win NT Promise FastTrak 376 (tm) Controller" driver has
been installed.
11. Power off your system.
12. Now you can move the boot drive to the FastTrak 376 Controller.
Your must first complete installing the driver before
101
Chapter 5 RAID Controller
Advertisement
Table of Contents
