Table of Contents
Advertisement
PRESYS
⏐ Instruments
2.0 - Installation
2.1 - Mechanical Installation
DMY-2030-F and DMY-2030-F Light Indicators front panel has 1/8 DIN size
(48 x 96 mm).
They are fixed by the rails which press them against the back side of the panel.
After preparing a 45 x 92 mm cut in the panel, remove the rails from the Indicator
and slide its rear through the cut until its front reaches the panel. Place the rails again in
the Indicator from the back of the panel and tighten the screws as shown in Figure 2.
Fig. 2 - Dimensional drawing, panel cutout and side view
2.2 - Electrical Installation
DMY-2030-F and DMY-2030-F Light Indicators may be powered by voltage
between 90 and 240Vac or 130 to 340Vdc, with any polarity. Remember that the internal
circuit is powered whenever the instrument is connected to the external power supply.
DMY-2030-F / DMY-2030-F Light
Installation
Page 5
Advertisement
Table of Contents
