Table of Contents
Advertisement
Installation Manual – Hardware Installation
BBU3806 WCDMA Base Band Unit
Different models of printers entail different feeding modes. Be sure to feed in the paper
pieces correctly.
V. Requirements for Printed Labels
Make sure that the printed labels satisfy the following requirements:
All the printout is on the label. Nothing should be printed on the bottom page of the
label.
Contents in the cells are aligned in the center. In a single-line printout, the dividing
lines and the mark "TO:" are not covered by the printed characters.
Avoid overwriting the mark "TO:" with contents in merged cells or multiple-line
printing. Use the space bar to move the contents to the next line.
C.2.5 Writing Labels
Use the black oiliness markers delivered together with the device to write the labels.
If have to, you may use black ball-pens instead. In that case, take care not to leave the
oil on the label. Note that the oil contaminates the label and blurs the words.
Note:
The delivered marker has two nebs. Be sure to use the smaller neb to write the labels.
For easy recognition and good looking, write close to the standard typeface. Table C-1
shows the standard typeface.
Table C-1 Standard typeface for handwriting
0
9
I
R
Write the characters in proper size and in the correct direction, as shown in Figure C-4:
1
2
3
A
B
C
J
K
L
S
T
U
Huawei Technologies Proprietary
Appendix C Engineering Labels for Cables
4
5
6
D
E
F
M
N
O
V
W
X
C-5
7
8
G
H
P
Q
Y
Z
Advertisement
Table of Contents
