Table of Contents
Advertisement
Installation Manual – Hardware Installation
BBU3806 WCDMA Base Band Unit
4)
Select the cells to merge and click [Table/Merge Cells].
If two merged cells are still not large enough, use multiple lines.
III. Requirements for Printer
Use a laser printer to print labels.
Before printing a label, set up the page and try the printing on ordinary blank paper
(both sides are blank):
1)
Cover the blank paper onto the whole page of label paper. Check that the page
setup conforms to the requirement.
2)
Make sure the printer properties, such as "paper size" and "direction", have been
set correctly.
3)
If the warning prompt as shown in Figure C-3 appears before printing, click
<Ignore> to continue the printing.
Figure C-3 Warning prompt before printing
If the printout conforms to the requirement, print it to label paper. If not, adjust the page
setup and try the printing again until the printout is satisfactory.
Adjust the page setup as follows:
1)
Click [File/Page Setup].
2)
Select the [Margins] tab page.
3)
Select "Left" for [Gutter Position].
4)
Set [Header] and [Footer] as 0. Adjust the values of [Top], [Bottom], [Left], and
[Right].
When the page setup is correct, save it for future use. The page setup is only necessary
for the first time you use the template to print the labels.
IV. Requirements for Feeding Printer
No matter what model of printer you are using, feed in paper pieces one after another
by hand. Never use the auto-feed mode to avoid jamming the labels. The reason is that
the label paper is different from the ordinary paper. It is composed of two pages and
processed through many stages.
Huawei Technologies Proprietary
C-4
Appendix C Engineering Labels for Cables
Advertisement
Table of Contents
