Table of Contents
Advertisement
Installation Manual – Hardware Installation
BBU3806 WCDMA Base Band Unit
A.3 Procedure
A.3.1 Cutting Cable
Cut the cable as follows:
1)
Load the cable coils on a support.
2)
Cut off a cable of the length required by the cable layout plan of the project
design, as shown in Figure A-2.
(1) Rolling direction
Figure A-2 Cable cutting
3)
Cut the cable with a handsaw.
Note:
You may use a saw blade (0.8 mm teeth spacing) or a KT35 wire clipper, if available,
for the cutting.
A.3.2 Mounting Heat Shrink Tube
Mount the heat shrink tube as required by the cable design onto the cable from the
end to strip.
Appendix A Making OT Terminal of Power Cable
Huawei Technologies Proprietary
A-2
Advertisement
Table of Contents
