Table of Contents
Advertisement
Installation Manual – Hardware Installation
BBU3806 WCDMA Base Band Unit
The length of the narrow part is designed for an external cable diameter of 2.6 mm.
After this part has been stuck to the back of the label, it may not overlap the entire
printed part.
3)
Fold the printed part along the dotted line according to the directions shown in
Figure C-5-b.
Figure C-5-c shows the finished label.
II. Affixing Label to Power Cable
Remove the label from the bottom page. Affix it to the rectangular flute on the ID plate
on the cable tie. Be sure to affix the labels on the same side of the ID plates. Bind the
cables with cable ties 20 mm from the connectors. You can change the position to suite
actual needs.
Bind the cables with cable ties at both ends. After the bundling, the finished ID plate
should be on top of the cable in horizontal cabling, or on the right side of the cable in
vertical cabling. Make sure that the label is facing out, as shown in Figure C-6.
Cable
Figure C-6 Appearance of affixed labels on power cables
C.2.7 Information Carried on Labels
I. For Power Cables
Affix labels for power cables on one side of the ID plates. On the labels, there is
information (the part after the mark "TO:") about the location of the device at the other
end of the cable, such as the location of the control cabinet, distribution box or power
socket.
TO:
B03
-48V2
Cable
Huawei Technologies Proprietary
C-7
Appendix C Engineering Labels for Cables
Advertisement
Table of Contents
