5.8
Closing the Unit
Closing the Unit
To close the unit, proceed as follows:
1. Tilt the unit to the horizontal position.
2. Place the front section on the casing.
3. Insert the CD-ROM ribbon cable and the CD-ROM audio line into
4. Press the front section onto the lower edge of the casing until the
5. Insert the battery into the battery compartment and connect it up.
6. Close the battery cover.
7. Connect the keyboard connector to the back of the unit. Make sure
8. Insert the keyboard cable in the cable conduit at the base of the de-
9. Allow the keyboard hinge to slide into the receptacles in the base of
10.Tilt the unit back into the operating position.
Your PG 720 is now ready for operation again.
PG 720 PII Programming Device
C79000-G7076-C756-02
the drive connector on the backplane.
catches in the base engage.
that the cable is inserted in its channel.
vice.
the device.
PG 720 Expansions
5-11