Table of Contents
Advertisement
Configuring the PG 720
Option "Boot
The following submenu appears when you select the option "Boot
Options"
Options" in the main menu:
Figure 6-5 "Boot Options" Submenu
Quick Boot
Mode
SETUP prompt
POST Errors
Floppy check
Summary
screen
'Enabled' means that the feature is active. 'Disabled' means that the
feature is inactive.
6-10
PhoenixBIOS Setup-Utility
Main
Advanced
Security
Power
Boot Options
[Enabled]
QuickBoot Mode:
SETUP prompt:
[Enabled]
POST Errors:
[Enabled]
Floppy check:
[Disabled]
Summary screen:
[Enabled]
F1
Help
Select Item
+ / –
ESC Exit
Select Menu
Enter Select
Some hardware tests are skipped to speed up the boot
procedure.
The message PRESS <F2> to enter Setup appears at the
bottom of the screen during the system run-up phase.
The boot process is stopped if an error is detected; you
must press F1 to acknowledge. Enter "Disabled"to avoid the
necessity of acknowledging errors, for example if no
keyboard is connected.
The floppy head is stepped inward and then back to its
original position during the system run-up phase. This test
is useful because it reinitializes the drive.
The most important system parameters are displayed when
the system run-up phase completes.
Boot Sequence
Version
Exit
Item Specific Help
Allows the system to skip certain
tests while booting. This will
decrease the time needed to boot
the system.
Change Values
F9
Setup Defaults
Sub-Menu
F10
Save and Exit
PG 720 PII Programming Device
C79000-G7076-C756-02
Advertisement
Table of Contents
