Table of Contents
Advertisement
Configuring the PG 720
Major components are shut down in suspend mode. The information
needed for reactivating the programming device is buffered.
Suspend Mode
Hard Disk
Timeout
Backlight
Fan Control
Battery Low
Condition
Resume on
Modem Ring
Resume On
Time
Resume Time
6-22
[Save to Disk]
In suspend mode all relevant data is
written to a defined sector of the
hard disk
[Save to DRAM]
In suspend mode all relevant data is
stored in main memory.
[Disabled]
The hard disk does not shut down.
[10, 15, 30, 60]
Time since the last hard-disk access,
the hard disk is shut down.
The next time it is accessed, the
hard disk starts spinning again
after a brief delay.
[Full on]
Display lighting is at full brightness
[reduced]
Brightness is reduced
[Disabled]
Fan always runs at full speed
[Enabled]
Fan speed depends on temperature.
[Save to Disk]
The Save to Disk mode is activated
as soon as the battery charge level
drops to minimum.
[Beeper]
When the battery charge level drops to
minimum the beeper sounds a warning
[Power Off]
At this setting, the device is shut down
when the charge level drops to
minimum.
[Off]
If this function is enabled, the
programming
[On]
device is reawakened from suspend
mode by the modem's "Ring" signal.
[On]
If this function is enabled the
programming device is automatically
switched on at the preset time.
[Off]
'Off' means this function is disabled.
Time for automatic restart
PG 720 PII Programming Device
C79000-G7076-C756-02
Advertisement
Table of Contents
