Table of Contents
Advertisement
Primary Master
The system jumps to the following submenu when you select this type
Primary Slave
of menu field:
Secondary Master-
Secondary Slave
Figure 6-3 Example: Primary Master
"Type" Field
The parameters you can select here are usually stored on the IDE
drive. The 'Auto' setting in the 'Type' field means that these values are
automatically read from the drive and written into memory
(Autodetect).
If Type is selected for a drive that cannot be detected, a timer times out
in approximately 1 minute and the entries remain unchanged. You
should always check that the interfaces for which you select 'Auto' are
in fact connected to drives.
Select "User" if you want to define the hard-disk type yourself, in which
case remember that you also have to set the other fields, including
Cylinder, Heads, Sectors/Track and WritePrecomp, to the correct
values for the type of hard disk in question.
PG 720 PII Programming Device
C79000-G7076-C756-02
PhoenixBIOS Setup Utility
Main
Advanced
Security
Primary Master [6495MB]
Type:
[Auto]
Cylinders:
[13424]
Heads:
[
Sectors
[
Maximum Capacity
6495MB
[16 Sectors]
Multi-Sector Transfers:
LBA Mode Control:
[Enabled]
[Enabled]
32 Bit I/O:
[FPIO 4 / DMA 2]
Transfer Mode:
[Mode2]
Ultra DMA Mode:
F1
Help
Select Item
+ / –
ESC Exit
Select Menu
Enter Select
Configuring the PG 720
Power
Boot Sequence
Version
Item Specific Help
[AUTO] (recommended)
Autotypes installed
IDE-devices
15]
63]
[USER]
Enter parameters of
IDE-devices installed
at this connection
Change Values
Setup Defaults
F9
Sub-Menu
F10
Save and Exit
Exit
6-7
Advertisement
Table of Contents
