Table of Contents
Advertisement
Configuring the PG 720
"Hardware
The following submenu appears when you select the "Hardware
Options" Field
Options" field in the main menu:
Figure 6-8
The parameters of the interfaces present on the basic module are set
here.
PCI-MPI/DP
Cardbus /
PCMCIA Slot
Programming
interface
CRT / LCD
selection
CRT 640 x 480
CRT 800 x 600
6-12
PhoenixBIOS Setup-Utility
Main
Advanced
Security
Power
Hardware Options
[Enabled]
PCI - MPI / DP:
[Enabled]
Cardbus/PCMCIA Slot:
Programming interface:
[Enabled]
CRT / LCD selection:
[SIMULTAN]
CRT 640 X 480:
[75 Hz]
CRT 800 X 600:
[75 Hz]
CRT 1024 X 768:
[75 Hz]
LCD-Screensize:
[Graph& Text Expand]
Trackball / PS/2 Mouse::
[Internal]
F1
Help
Select Item
+ / –
ESC Exit
Select Menu
Enter Select
"PG 720 PII Hardware Options" Submenu
Entry
Enables the CP5611-compatible MPI/DP interface. The
recourses are managed by the BIOS PCI plug & play
mechanism.
[Disabled]
[Enabled]
Enables or disables the interface for SIMATIC S5 memory
modules and SIMATIC memory cards. This interface uses
the I/O address range 300h-31fh.
[LCD Enabled]
[CRT Enabled]
[SIMULTAN]
Refresh rate with a resolution of 640x480 pixels
Refresh rate with a resolution of 800x600 pixels
Boot Sequence
Version
Exit
Item Specific Help
Enable or disable the Plu
PCI - Multi Point
Interface (MPI / DP)
Change Values
F9
Setup Defaults
Sub-Menu
F10
Save and Exit
Meaning
Disables the Cardbus / PCMCIA
interfaces.
The resources are managed by the BIOS
PCI plug & play mechanism.
All data is output only to the internal
LCD, the 15-way VGA port is disabled
For maximum resolution the display
signals are output only to the 15-way
VGA port; the LCD interface of the VGA
controller is disabled.
Both display interfaces are enabled
and operate simultaneously. Note,
however, that the LCD does not
support all resolutions.
PG 720 PII Programming Device
C79000-G7076-C756-02
Advertisement
Table of Contents
