HIKVISION AX PRO User Manual page 92

Repeater
The repeater can amplify signals between the control panel and the peripherals.
Steps
1. Click Device Management → Mount Device → Repeater to enter the page.
– Click to view the serial number and linked device number.
– Click to view the device status, battery status, signal strength, main power and version.
2. Click +Add to add a repeater.
3. Click Enable Paring Mode(Cam-X) to make the repeater enter the mode of device paring.
When the distance between the peripheral and the control panel is far, the repeater can be used
as a transfer station for pairing. The pairing mode lasts for 3 minutes and cannot be interrupted.
After the pairing is successful, a list of connected devices will be displayed.
4. Click to edit the repeater parameters.
5. Click to enter the Manual Retransmission Rules page.
6. Select devices in the list and click OK, and then the devices can be manually retransmitted.
Module/Transmitter
You can set the parameters of the transmitter.
Steps
1. Click Device Management → Mount Device → Module to enter the page.
– Click to view the serial number and linked device number.
– Click to view the device status, battery status, signal strength, main power and version.
Figure 5-19. Repeater Settings
Figure 5-20. Manual Retransmission Rules
91