HIKVISION AX PRO User Manual page 68

System Management
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → System Management to enter the page.
Panel Sound Prompt
If the option is enabled, the AX PRO will enable the voice prompt.
-System Volume: The available system volume range is from 0 to 10.
-Fault Prompts When Armed: Voice prompt of faults when the system is armed.
-Fault Prompts When Disarmed: Voice prompt of faults when the system is disarmed.
-Alarm Prompts: Voice prompt of faults when an alarm is triggered.
Panel LED Display
Enable/Disable panel functional LED.
Arm LED/Cloud LED
Enable arm/cloud LED indicator.
Fault LED Stays On When Armed
After arming, the fault indicator remains on.
System Alarm Duration
Set linked alarm voice prompt lasting time.
Audible Tamper Alarm
While enabled, the system will alert with buzzer for the tamper alarm. Regardless of whether
it is enabled or not, the tamper alarm will be normally pushed to Cloud (for APP) and ARC.
Bypass on Re-Arm
While enabled, after the detector is bypassed, if its faults are restored and the linked area is
armed, the detector will automatically arm.
Jamming Sensitivity Settings
The device will detect RF interference and push messages when the RF interference
interferes with communication. You can adjust the detection sensitivity.
Motion Detector Restore
Motion detectors include all PIR detectors.
-Disable: No automatic restore.
-Immediate After Alarm: Motion detectors automatically restores immediately after the
alarm and reports to Cloud (for APP) and ARC.
-After Disarm: Motion detectors automatically restores after disarming and reports to Cloud
(for APP) and ARC
Power Saving Mode
While enabled, the main power supply is off, Wi-Fi enters low power consumption, 4G closes,
tag reading fails, LED off, and voice prompt off.
67