HIKVISION AX PRO User Manual page 69

Panel Fault Check
The fault check here is only for the control panel in the normal status.
The system determines whether to check the faults listed on the page. The system will only check
the fault that is selected.
Steps
1. On the device list page, tap the AX PRO and then log in to the device (if required) to enter the
page.
2. Tap → System → System Options → Panel Fault Check to enter the page.
Report Delay
If the fault returns to normal within the delay duration, no fault will be reported.
IP Camera Disconnection
This option only appears if a camera has been added to AX PRO.
If the option is enabled, when the linked network camera is disconnected, an alarm will be
triggered. The delay time of network camera disconnection detection is the same as that of
LAN.
Battery Lost
If the option is enabled, when panel battery is disconnected, the device will upload events.
Low Battery
If the option is enabled, when panel battery is in low battery status, the device will upload
events.
LAN Lost
If the option is enabled, when the wired network is disconnected or with other faults, the
alarm will be triggered.
WiFi Lost
If the option is enabled, when the Wi-Fi is disconnected or with other faults, the alarm will be
triggered.
Cellular Lost
If the option is enabled, when the cellular data network is disconnected or with other faults,
the alarm will be triggered.
Panel Mains Power Lost
If the option is enabled, an alarm will be triggered when the control panel main supply is
disconnected.
Arming Options
This function is for the whole alarm system, to inform the user of the current system status before
arming. If it is enabled, there will be a fault prompt and confirmation process for tag readers,
68