Christie D Series Service Manual page 83

KEYPAD PCB block (REMOTE-R / KEYPAD PCB, CONTROL BUTTON, STATUS MONITOR)
KEYPAD PCB (PWB ASS'Y KEYPAD)
Disassembling
1) Remove three screws to separate the KEYPAD PCB from the CONTROL BUTTON.
3) Remove 2 screws.
Assembling
2) Tighten 2 screws.
Wiring
Refer to page 61 for wiring.
Sub-LCD PCB
Disassembling
Flip the stopper of ER50 (FPC connector) to release the FPC cable of the STATUS MONITOR,
disconnect cable (CNLCD) and
4)
3)
Assembling
Set Sub-LCD PCB , connect a cable (CNLCD) and connect the FPC cable as shown in next page
in detail.
LWU701i/LW751i/LX801i/LWU601i/LW651i
Service Manual
LWU701i / LW751i / LX801i / LWU601i / LW651i
T3x8 screw (black, 0.49±0.1N·m) for the KEYPAD PCB
Pay attention not to use wrong screws such as T3x12
used for fastening inner parts to the BOTTOM CASE.
Sub-LCD PCB
82
KEYPAD
PCB
1)
020-000793-01
LIT MAN SERV D2