Christie D Series Service Manual page 47

6-17 Status Monitor
The Status Monitor is the sub LCD in the rear panel. The Status Monitor
displays the present condition of the projector including errors, setup
information and error history.
NOTE:
monitor are available while the projector is in standby mode if the
STANDBY MODE item of SETUP menu is set to POWER SAVE.
contents on the Status Monitor are displayed upside down.
Displaying the condition of the projector
If no buttons have been operated, the Status Monitor displays as below depending on the condition
of the projector.
In a normal state
The Status Monitor displays the state of the projector in three lines.
1st line
: Displays the condition of the projector. While the lamp is on,
the selected port is displayed.
Displayed conditions are as below;
STANDBY: The projector is in standby mode.
WARM UP: The projector is warming up.
SEARCHING: The projector is searching an input signal.
COOL DOWN: The projector is cooling down.
: Displays the condition of the detected input signal while the lamp is on. Otherwise,
2nd line
displays the serial number of the projector.
Displayed conditions are as below;
SYNC OUT
NO SIGNAL: There is no input signal.
CONNECTED
transferred to the projector while the LAN port is selected.
HOLD
selected.
NOT CONNECTED
selected.
: Displays supplied voltage and peripheral temperature in Celsius while the lamp is on.
3rd line
NOTE:
2nd line of the monitor.
temperature is measured inside of the projector.
LWU701i/LW751i/LX801i/LWU601i/LW651i
Service Manual
LWU701i / LW751i / LX801i / LWU601i / LW651i
46
Status Monitor
S T A N D B Y
1 2 3 4 5 6 7 8 9 0 A B
2 3 ° C
example
LAN port is
LAN port is
020-000793-01
LIT MAN SERV D2