Table of Contents
Advertisement
5
EPC-26A/27 Hardware Reference
EXM CONFIGURATION ERROR
Problem:
The EXMs installed (or not installed) do not match the configuration
information in the BIOS setup EXM menu.
Solution(s): Run the BIOS setup program. Enter the EXM menu. Verify the
information listed on the screen, save any changes and reboot.
If necessary, refer to the section EXM Setup Screen, in Chapter 2 of
this manual and/or your EXM manual(s) for more details.
DISKETTE DRIVE A ERROR
Problem:
The configuration information in the BIOS setup says that one or
more floppy disk drives are expected, but a floppy disk controller
could not be found.
Solution(s): If you have no floppy diskette drives, enter the setup program and set
5
both floppy drives to "NONE."
If you are using a floppy drive(s), verify that both the floppy
controller and the floppy drive(s) have power.
GENERAL FAILURE READING DRIVE ...
Problem:
This almost always indicates the presence of an unformatted hard disk
partition or diskette.
Solution(s): Format the partition or diskette using the utilities supplies by your
operating system.
INVALID DRIVE SPECIFICATION
Problem:
You are trying to access a logical drive (e.g., A:, B:, ...) that is not
known to the operating system.
Solution(s): Select a different logical drive. If you are trying to access a hard disk,
you may need to create the logical partition.
Page 34
BIOS
BIOS
DOS
DOS
Advertisement
Table of Contents
