Table of Contents
Advertisement
2
Note that there are some restrictions when setting up devices on the EPC-
26A/27. If you plan to boot from a non-IDE device, such as the resident Flash
memory, set the master drive as None and use the BIOS extension. You
cannot boot from Flash and still have an IDE drive; the IDE drive must be
drive C: if it is to be used. Flash BIOS extensions are enabled and configured
2
in the Advanced Menu.
Once you have completed the setup for the IDE Master, you can choose the
IDE Adapter 0 Slave Sub-menu to configure your second drive. When
finished, press the ESC key to return to the Main Menu.
Boot Sequence Sub-Menu
The Boot Sequence Sub-Menu allows you to change the boot sequence
options. The following displays:
PhoenixBIOS Setup
Boot Delay:
Boot Sequence
SETUP Prompt:
POST Errors:
Floppy Check:
Summary Screen:
F1
Help
ESC
Exit
Boot Delay:
Use this option to set the system to delay booting for a time period in seconds
that you set. This allows for long start up times on boot devices that spin up
slowly. The default is zero.
Page 8
EPC-26A/27 Hardware Reference
-
Copyright 1992-94 Phoenix Technologies Ltd.
Boot Options
[0]
[A: then C:]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
Select Item
-/+ Change Values
Select Menu
Enter Select
Sub-Menu
Figure 2-3. Boot Sequence Sub-Menu.
Item Specific Help
F9 Setup Defaults
F10 Previous Values
Advertisement
Table of Contents
