Case Connectors: Jfp1/Jfp2 - VIA Technologies P4XB-S User Manual

Case Connectors: JFP1/JFP2

The case connector blocks JFP1 & JFP2 allow you to connect to the Power
Switch, Reset Switch, Speaker, Power LED, and HDD LED on the case.
Power Switch
Connect to a 2-pin push button switch. Pressing this button will turn the
system power on or off.
Reset Switch
The Reset Switch is used to reboot the system rather than turning the power
ON/OFF. Avoid rebooting while the HDD is working. You can connect the
Reset Switch from the system case to this pin.
Power LED
The Power LED is lit while the system power is on.
Speaker
The speaker from the system case is connected to this pin.
If on-board Buzzer is available: Short pin 14-15:
HDD LED
HDD LED shows the activity of a hard disk drive. Avoid turning the power off
while the HDD LED is lit. You can connect the HDD LED from the system case
to this pin.
JFP1
Open pin 14-15:
2-21
Installation
Speaker
Dual Color
Single Color
Power LED
PLED
JFP2
HDD
LED
On-board Buzzer Enabled.
On-board Buzzer Disabled.
Power
Switch
Reset
Switch