VIA Technologies P4XB-S User Manual page 57

The onboard parallel port is EPP Spec. compliant, so after the user chooses
the onboard parallel port with the EPP function, the following message
will be displayed on the screen: "EPP Mode Select." At this time either
EPP 1.7 spec or EPP 1.9 spec can be chosen.
ECP Mode Use DMA
The ECP mode has to use the DMA channel, so choose the onboard
parallel port with the ECP feature. After selecting it, the following mes-
sage will appear: "ECP Mode Use DMA." At this time, the user can choose
between DMA channel 3 or 1.
PWRON After PWR-Fail
This setting specifies whether your system will reboot after a power fail-
ure or interrupts occurs. Available settins are:
Off
On
Former-Sts
interrupt occurs.
Game Port Address/Midi Port Address
This setting disables or assigns an address for the onboard game/midi
port.
Midi Port IRQ
This setting specifies an IRQ for the onboard midi port.
Init Display First
This setting specifies which VGA card is your primary graphics adapter. Set-
ting options: PCI Slot and AGP.
OnChip USB Controller
This setting allows you to activate the onchip USB controller. Setting options:
All Disabled, All Enabled, 1&2 USB Port, 2&3 USB Port, 1&3 USB Port, 1
USB Port, 2 USB Port, 3 USB Port.
USB Keyboard/Mouse Support
Set to Enabled if your need to use a USB keyboard/mouse in the operating
system that does not support or have any USB driver installed, such as DOS
and SCO Unix. Setting options: Disabled, Enabled.
Leaves the computer in the power off state.
Reboots the computer.
Restores the system to the status before power failure or
3-49
BIOS Setup