Table of Contents
Advertisement
Black(K) Density: Adjusts the black or other monochrome ink density.
Adjustments may be needed to optimize barcode printing.
If the density is too high, a barcode's elements may be too thick and
unreadable. If the density is too weak, the barcode may be too thin and
also unreadable with a barcode scanner.
Resin(X) Density: To set the printing density for the resin (such as holograms)
panel. If the density is too strong, the resin panel looks a little blurry, as
shown in the Figure, and the ribbon folds and stripes appear. Also, if
density is too weak, the resin panel will not print as on the red line in right
figure. To check the transcribed part, it's easy to see it if you look at it
obliquely in the light. Therefore, set the print density to be evenly printed
throughout the card by adjusting the print density.
⑧
Print calibration card.
⑨
Advanced setup.
(These options should NOT be changed unless directed by IDP Support)
⑩
Save and Load Configuration
Get Config.: Retrieve values from current printer.
Set Config.: Set values to current printer.
Load from File: Load values from file.
Save to File: Save values to file.
Close: Close CardPrinterConfig.
60
Advertisement
Table of Contents
