idp SMART-81 User Manual page 29

The table below details LCD messages based on the laminator's status and functions.
Messages KEY0
Menu/Cancel
L Film Zero+ x
Plz Error
Clear
L Film Empty+ x
Plz Error Clear
L
x
xxxxxxxxxxxxx+
Plz Error Clear
DeviceCon Error
x
Plz Error Clear
DeviceCon Error
Retry device
connect
AnyKet Retry
Ribbon Count 0 x
Open a Case!
Ribbon Count 0 x
Change a
Ribbon
Ribbon Count 0
x
RibType
Mismatch
KEY1 KEY2
Left/Down Right/Up
x x
x x
x x
x x
Retry device Retry device
connect connect
x x
x x
x x
29
KEY3 State
Select/OK
x Laminator
error
x Laminator
error
x Laminator
error
x Devices
connect
error
Retry device Device
connect connect
error
x
x Ribbon
change
x Ribbon
change
Description
Laminator Film supply is
empty. Install new Laminate
film. A '+' is displayed at
the end of first line if there
are more than two errors
Laminator Film is not
installed. A '+' is displayed
at the end of first line if
there are more than two
errors
Laminator initialization
error: Head Overheat,
temperature Setting error.
(Refer to Laminator LCD
Error Table)
Connected device (e.g.,
Laminator, Flipper) is not
recognized.
The 81 Laminator
connected is not
recognized. Turn off IRDA
communication and retry.
Ribbon is count zero after
front side print during
both-side print. Install a
new ribbon
Ribbon is count zero after
front side print during
both-side print. Install a
new ribbon
Ribbon is count zero after
front side print during
both-side print. Install a
new ribbon. Be sure to use
a ribbon that is encoded
for your printer's region.