KEB COMBICOM Instruction Manual page 13

Powerlink Operator
Default value:
Notice:
Name:
Meaning:
Combivis-
Parameter address:
SDO-Index:
SDO-Subindex:
Data length:
Access:
Coding:
Default value:
Notice:
Name:
Meaning:
Combivis-
Parameter address:
SDO-Index:
SDO-Subindex:
Data length:
Access:
Coding:
Default value:
Notice:
Name:
Meaning:
Combivis-
Parameter address:
SDO-Index:
SDO-Subindex:
Data length:
Access:
Coding:
1: Write default values of all non-voletile parameters into the non-voletile memory.
This values are not active before the next restart of the PowerLink-operator.
0
For confirmation that the operator has executed the requested command, the operator
sets Bit 15 to value 1 after conclusion of the command.
Watchdog Activation (Fb07)
Defines the activation of the fieldbus-watchdog after POWER On.
0287h
2287h
0
1 Byte
READ_WRITE
0: The Fieldbus-Watchdog is active immediately.
Values unequal to Zero are bitcoded:
Bit0 : Activation of the Fieldbus-Watchdog after the first SoC-interrupt
Bit1: reserved
Bit2: Activation of the Fieldbus-Watchdog after the first transition of the
PowerLink(FPGA) into state operational.
Bit3: Activation of the Fieldbus-Watchdog after the first receive of PDOUT-data.
Bit4: reserved
Bit5: Activation of the Fieldbus-Watchdog after the first receive of a SDO-demand.
04h
A new value takes effect immediately and is stored non-volatile.
Watchdog Inhibit (Fb08)
Defines the events that reset the fieldbus-watchdog. The bitcoding of this parameter
makes it possible to define more than one event for resetting the fieldbus-watchdog.
0288h
2288h
0
1 Byte
READ_WRITE
Bit coded:
Bit0 :Reset of the Fieldbus-Watchdog after receive of PDOUT-data.
Bit1: Reset of the Fieldbus-Watchdog after receive of a SDO-demand.
Bit2: Reset of the Fieldbus-Watchdog, if a link-signal is set at Port0 or Port1 of the Po
werlink-opterator.
Bit3: Reset of the Fieldbus-Watchdog after receive of a SoC-interrupts.
Bit4: Reset of the Fieldbus-Watchdog, if the Powerlink-status (FPGA) is operational.
07h
A new value takes effect immediately and is stored non-volatile.
FBS Config (Fb09)
Serves for configuration of some special functions in the Powerlink operator.
0289h
2289h
0
2 Byte
READ_WRITE
Bit coded:
GB - 13