Operation; Pre-Start; Mowing; Bagger Removal For Side Discharge - Exmark Ultra VAC QDS Lazer Z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983

4. OPERATION:

4.1 PRE-START

4.1.1 Read the operator's manual for your mower and familiarize yourself with all
4.1.2 Ensure the blower, belt cover, door mesh, tube and hopper are in good condition,
Note: When mowing in areas with sandy soil, use low lift blades on the cutting
deck and higher cutting heights to minimize wear on the blower components.

4.2 MOWING

4.2.1 The Ultra Vac QDS blower operates when deck drive is engaged. Be sure that all
4.2.2 To disengage the PTO and blower, set the throttle to "midway" position. Push in
4.2.3 To empty the hopper, first shut off deck drive. Lift up on the handle to open the
4.2.4 Close and latch the door before continuing mowing. Do not engage the cutting

4.3 BAGGER REMOVAL FOR SIDE DISCHARGE:

4.3.1 Disengage the PTO, stop engine and wait for all moving parts to stop. Remove
4.3.2 Remove the discharge tube by releasing the latch at the blower. Slide the tube
4.3.3 Remove the Belt cover by loosening the knobs. For 60" units the outboard knob
4.3.4 Pull the idler release handle and remove the belt from the upper groove of the
4.3.5 Unlatch the front end of the blower. Pivot the blower back and lift it off the deck.
4.3.6 Install the discharge chute using the chute pivot pin and hairpin (See Figure 16).
controls before operating the machine. Make sure that you understand the
controls, their locations, their functions, and their safety requirements.
properly attached, and latched.
persons are clear of the mower deck before engaging the cutting blades. Set
the throttle to "midway" position. Pull outward on the PTO switch to the
"ROTATE" position. Accelerate to full throttle to begin mowing.
on the PTO switch to the "STOP" position to stop the cutting blades and blower.
The cutting blades will require a slightly longer amount of time to come to a
complete stop when the blower is installed on the deck. Verify that all rotation
indicators have stopped before clearing blower assembly or mower deck
door and empty the hopper. If the unit is to be driven onto a truck or trailer
with the hopper full, always back the unit up the ramp. This will reduce the
chance of rearward tip up. See section 4.1 Transporting for additional
information regarding loading a unit on a truck or trailer.
blades while the door is in the open position.
spark plug wire(s) or remove key.
off the blower outlet and remove the upper end from the hopper.
does not need to be removed completely to remove the belt cover.
POTENTIAL HAZARD
♦ The deck sheave will become very hot
WHAT CAN HAPPEN
♦ Touching a hot deck sheave can cause severe burns.
HOW TO AVOID THE HAZARD
♦ Allow the deck sheave to cool completely before
removing the belt.
deck sheave.
www.mymowerparts.com
CAUTION
18