Install Hopper Assembly - Exmark Ultra VAC QDS Lazer Z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.2 INSTALL THE HOPPER ASSEMBLY
Lazer Z units only (Lazer Z XP units skip to section 3.2.8)
3.2.1 When installing the Ultra Vac QDS onto a liquid cooled Lazer Z, the rear bumper
3.2.2 Remove the lower two screws holding the rear engine guard ("HOT" engine guard
3.2.3 On units with serial numbers 190,000 and higher install the mount weldment (Item
3.2.4
plate must be removed. Remove rear bumper plate. Reattach the lower side
bumper bars to the vertical "HOT" engine guard shield using two of the original
screws, washers and whizlock nuts removed from the bumper plate.
on liquid cooled units) to the rear frame of the Lazer Z unit. Units with serial
numbers 149,999 and below will require disassembly of the clutch strap spacers
to remove these screws.
9) loosely to the rear of the machine using the two screws and nuts removed in
section 3.2.2.
For units with serial numbers 189,999 and below, install washers (Item 31)
between the bagger mount weldment and clutch guard when installing the bagger
mount weldment. This will provide for proper alignment of the mount holes with
the holes in the hopper assembly. See figure 1.
For units with serial numbers 149,999 and below, remove the two tap bolts that tie
the clutch straps to the rear engine guard and replace with new tap bolts (Item 32).
These units also require the use of the washers (Item 31) between the bagger
mount weldment and the rear engine guard. These parts should be installed when
the bagger mount weldment is installed on the rear of the unit. See figure 1.
Jack the rear of the unit up and safely support it on jack stands. Remove the
rear wheels.
POTENTIAL HAZARD
♦ Relying solely on mechanical or hydraulic jacks to
support the mower could be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may malfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
www.mymowerparts.com
FIGURE 1
CAUTION
7
FOR SN 149,999
AND BELOW ONLY