Assemble Tubes - Exmark Ultra VAC QDS Lazer Z Operator's Manual

For Exmark Mower Parts Call 606-678-9623 or 606-561-4983
3.3.11 Install the belt (Item 13) onto the blower by working it around the impeller sheave.
3.3.12 72" units serial number 259,999 and below will require the deck to be modified by
3.3.13 Mount the blower on the deck by sliding the mounting pin into the tube at the rear
3.3.14 Pull the spring loaded idler back and slip the belt over the top sheave on the deck
3.3.15 Install the plastic belt cover (Item 10). On 60" units the outside end of the cover is
3.4 ASSEMBLE THE TUBES
3.4.1 Remove the screws, nuts, and washers (Items 4, 5, and 6) from the lower tube
adding the accessory mounting tube. Exmark kit 103-0583 contains the parts and
templates required. Follow the instructions in this kit. These decks will also
require drilling the hole at the front upper corner of the discharge opening to ½
inch diameter. (See Figure 9). Touch up with red paint Exmark P/N 1-850337.
right corner of the deck. Swing the blower closed. Adjust the position of the front
pin to engage the slot in the front of the deck. Use the latch to lock the blower in
this position. Adjust the tension on the latch to draw the blower up to the deck,
yet allow for release by hand.
spindle.
slotted and can slip between the two washers assembled in step 3.3.9. The
plastic knob does not need to be removed. On 72" units the cover has a hole,
and the plastic knob must be installed after the cover has been positioned.
(Item 3) and slide the lower and upper tube (Item 2) together. The arrow on the
upper tube should align with the dimple on the lower tube. There are two sets of
holes on the lower tube. The first set reached is for use with Lazer XP units. The
second set reached is for Lazer Z units. Align the arrow on the upper tube with
the dimple on the lower tube and slide them together until the proper set of holes
is reached.
www.mymowerparts.com
FIGURE 8
FIGURE 9
13