Product Overview; Operation; Pre-Start; Operating Instructions - Exmark ULTRAVAC BAGGER 126-6954 Operator's Manual

Operation

Product Overview

Figure 3
1. Hopper
2. Toeboard weight
3. Blower
g037093
4. Tube
5. Bag
Operation
Note: Determine the left and right sides of the
machine from the normal operating position.
Important: Multiple accessories added to a base
unit can change the stability of the machine.
Read the unit operator's manual to determine
if counterbalance weights are necessary for the
accessories installed on the unit.

Pre-Start

Make sure you understand the controls, their
locations, their functions, and their safety
requirements.
Ensure the blower, belt cover, bags, tubes and hopper
are in good condition, properly attached, and latched.
Important: Verify that the reinforced bumpers
are installed on your unit prior to operation.
Refer to the Maintenance section and perform all the
necessary inspection and maintenance steps.

Operating Instructions

Mowing
1. The UltraVac blower operates when the PTO
is engaged. Be sure that all persons are clear
of the mower deck before engaging the cutting
blades. Set the throttle to "midway" position. Pull
outward on the PTO switch to the "ROTATE"
position. Accelerate to full throttle to begin
mowing.
2. To disengage the PTO, set the throttle to
"midway" position. Push in on the PTO switch
to the "STOP" position to stop the cutting blades
and blower. The cutting blades will require a
slightly longer amount of time to come to a
complete stop when the blower is installed on
the deck. Verify that all rotation indicators have
stopped before clearing blower assembly or
mower deck.
3. To remove the bags, first disengage the PTO, stop
the engine and wait for all moving parts to stop.
Open the hopper and remove the bags by lifting
up on the rear of the bag, then unhooking the
front clip. Empty the bags by inverting them.
4. Reinstall bags, close and latch hopper before
continuing mowing.
10