Product Overview; Operation; Controls - Exmark VERTEX X Series Operator's Manual

Operation

Product Overview

1
Figure 3
1. Deck lift and Height of
cut
2. Park brake lever
4
3
4
2

3. Controls

4. Motion controls
Operation
Note: Determine the left and right sides of the
machine from the normal operating position.
Controls
Note: Become familiar with all the controls before
starting the engine and operating the machine.
Motion Control Levers
There are two sets of motion control levers, located
in front and behind the reference bar on the top
console, that control the forward and reverse motion
of the machine.
g375400
1. LH Motion forward
control lever
2. RH Motion forward
control lever
3. Reference bar
4. LH Motion reverse
control lever
5. RH Motion reverse
control lever
6. Throttle
Moving the levers forward or backward turns
the wheel on the same side forward or reverse
respectively. Wheel speed is proportional to the
amount the lever is moved.
20
Figure 4
7. Height of cut lever
8. Ignition
9. Message display
10. PTO engagement switch
11. Choke (All Models
Except EFI)
12. Park brake
g344685