Installation And Connection; Connecting The Grill And Side Burner - Cal Flame BBQ08874CP Owner's Manual

Installation and Connection

Connecting the Grill and Side Burner

These instructions show you how to connect a grill only or a grill and side burner combination.
If you plan to convert to your grill from LP to NG, you need to do this before it is connected to a gas source.
Grill conversion instructions can be found on page 33 and ordering information can be found in this manual on
page 38. There are a few differences between connecting to LP and NG.
1 . Attach the Transformer
All grills with electrical components such as lights or a convection
fan will require the transformer to be installed and plugged in before
you can use it. This needs to be done before the grill is inserted
in the island. When the transformer is attached to the grill chassis,
use care in placing the grill in the island cutout to avoid hitting the
transformer.
1. Remove the transformer and the metal screws from the plastic
bag.
2. Place the grill on a sturdy surface and tilt it back to show the
underside of the grill.
3. Using the metal screws, attach the transformer
to the left side of the grill near the internal
electrical connection. Attach the metal plate to
the outside surface of the grill as shown in the
figure below.
Convection Grills
LTR50001038, Rev. J
4. When you have firmly tightened the screws and
nuts, connect the plug from the transformer to the
grill. Screw on the stainless steel retainer.
11
www.cal amebbq.com