Omron NX Series Network Connection Manual page 35

6.4.2. Checking the Receive Data
In the Sysmac Studio, check that correct data is written to the controller variables.
1
Check the received data (read
code) in the Watch Tab Page of
the Sysmac Studio.
* In the example figure on the
right, the data stored in
RecvStringDat is
"4912345678904".
* The contents of the read
barcode are stored in
RecvDat[0] to RecvDat[12].
2
Then, use the code reader to
read the code shown in the
figure on the right.
3
RecvStringDat and RecvDat are
updated, and you can see that
the contents of the code just
read are stored.
6. Connection Procedure
32