Omron NX Series Network Connection Manual page 27

Auto focus multi code reader

Hide thumbs Also See for NX Series:

Table of Contents

The Communications Setup

Dialog Box is displayed.

Make sure that the Ethernet

connection via a hub Option is

selected in Connection type.

Also, enter 192.168.188.1 in

Remote IP Address.

Click on Ethernet

Communications Test and

confirm that Communications

test OK is displayed.

Click OK.

Select Online from the

Controller Menu.

A confirmation dialog box

appears. Click Yes.

* The dialog box displayed

differs depending on the status

of the controller being used.

Select Yes to proceed with the

operation.

* The serial IDs displayed vary

depending on the device.

Note

Refer to Section 6 Online Connections to a Controller in the Sysmac Studio Version 1

Operation Manual (Cat. No. W504) for details on online connection to the controller.

6. Connection Procedure

Table of Contents

Nj series V320-f series V330-f series V420-f series V430-f series