Omron NX Series Network Connection Manual page 20

9
The WebLink screen appears.
10
Click on the Setup Tab and, in
Read Cycle Sequence, set
Cycle to Triggered.
11
Click on the gear icon on the
upper right of the screen and
select Advanced.
12
The Advanced Settings Screen
appears.
Select the Communications
Tab and check that the settings
are as follows.
[RS232A]
Baud Rate: 115.2 K
Parity: None
Stop Bits: One
Data Bits: Eight
[Host Protocol]
Protocol Selection: Point-to-
Point
[Preamble]
Preamble: Disabled
[Postamble]
Postamble: Enabled
Postamble Characters:
<CR><LF>
6. Connection Procedure
17