Connection Procedure; Operation Flow - Omron NX Series Network Connection Manual

6. Connection Procedure

This section describes the procedures for connecting the code reader to the controller for
serial communications.
In this document, it is assumed that the controller and the code reader use the factory default
settings. For how to initialize the devices, refer to Appendix 1. Initializing the System.

6.1. Operation Flow

Use the following procedures to set up the controller for serial communications connection.
6.2. Code Reader Setup
▼
6.2.1. Setting the Communication
Parameters
▼
6.2.2. Setting the Parameters

6.3. Controller Setup
▼
6.3.1. Setting the Hardware
▼
6.3.2 Starting the Sysmac Studio
and Loading the Project File
▼
6.3.3 Checking the Parameters
and Executing Build
▼
6.3.4 Going Online and
Transferring the Project
Data
▼
6.3.5. Transferring the Unit
Settings

6.4. Checking That Serial
Communications Work
▼
6.4.1. Executing the Program
▼
6.4.2. Checking the Receive Data
Set up the code reader.
Set the communication parameters for
communications between the code reader and
the NX Unit.
Set the parameters for the code reader.
Set up the controller.
Check the connection of the Serial
Communications Unit.
Start the Sysmac Studio and load the project
file.
Check the setting parameters. Then, perform
program checks and build on project data.
Place the Sysmac Studio online and transfer
the project data to the controller.
Transfer the setting data for the Serial
Communications Unit.
Execute the program to check that serial
communications work correctly.
Execute the program in the Sysmac Studio.
In the Sysmac Studio, check that correct data
is written to the controller variables.
6. Connection Procedure
13