Omron NX Series Network Connection Manual page 24

6.3.3. Checking Parameters and Executing Build
Check the setting parameters. Then, perform program checks and build on project data.
1 Double-click Built-in
EtherNet/IP Port Settings
under Configurations and
Setup – Controller Setup in
the Multiview Explorer.
2
The Built-in EtherNet/IP Port
Settings Tab Page is displayed
in the Edit Pane.
Select TCP/IP, select the Fixed
setting Option in IP Address,
and check that the settings are
as follows.
IP Address: 192.168.188.1
Subnet mask: 255.255.0.0
Default gateway: _._._._
Check that Keep Alive is set as
follows.
Keep Alive: Do not use
Linger option: Do not specify
3 Double-click I/O Map under
Configurations and Setup in
the Multiview Explorer.
The I/O Map Tab Page showing
Tab Page showing the unit
parameters is displayed.
4 In the I/O Map Tab Page, check
Node location information
under NX-CIF210.
Confirm that the Variable
column shows
N1_Node_location_information.
6. Connection Procedure
21