Kia CARNIVAL 2023 Manual page 132

Features of your vehicle
Driver Position Memory Sys-
tem (if equipped)
The driver position memory system is
provided to store and recall the following
memory settings with a simple button
operation.
OKA4040468R
僅 Driver's seat position
僅 Outside rearview mirror position
WARNING
Never attempt to operate the driver
position memory system whilst the vehi-
cle is moving.
This could result in loss of control, and
an accident causing death, serious
injury, or property damage.
NOTICE
僅 If the battery is disconnected, the
memory settings will be erased.
僅 If the Driver Position Memory System
does not operate normally, have the
system checked by a professional
workshop. Kia recommends to visit an
authorised Kia dealer/service partner.
4 22
Driver Position Memory System
Storing memory positions
1. The ignition switch or ENGINE START/
STOP button is in the ON position.
2. Adjust the driver's seat position, out-
side rearview mirror position and
instrument panel illumination intensity
to the desired position.
3. Press the SET button. The system will
beep once and notify you "Press but-
ton to save settings"on the LCD dis-
play.
4. Press one of the memory buttons (1 or
2) within 4 seconds. The system will
beep twice when the memory has
been successfully stored.
5. "Settings 1 (or 2) saved" will appear on
the LCD display.
Recalling memory positions
1. The ignition switch or ENGINE START/
STOP button is in the ON position.
2. Press the desired memory button (1 or
2). The system will beep once, and
then the driver's seat position, outside
rearview mirror position, instrument
panel illumination intensity and head-
up display height/brightness will auto-
matically adjust to the stored posi-
tions.
3. "Settings 1 (or 2) applied" will appear
on the LCD display.
僅 Whilst recalling the "1" memory posi-
tion, pressing the SET or 1 button tem-
porarily stops the adjustment of the
recalled memory position. Pressing
the 2 button recalls the "2" memory
position.
僅 Whilst recalling the "2" memory posi-
tion, pressing the SET or 2 button
temporarily stops the adjustment of
the recalled memory position. Press-
ing the 1 button recalls the "1" memory
position.