Installation Instructions - M&C MP Series Instruction Manual

14

INSTALLATION INSTRUCTIONS

When installing the pump make certain that accident prevention regulations and safety instructions including
those for subsequent operation are observed. The safety instructions in chapter 8.1 Safety must be observed.
Note
The protection class of the pumps MP47, MP47-Z, MP47/R, MP47-Z/R, MP47D is IP20 and so offer no protection
against contact or foreign bodies.
Warning
Note
www.mc-techgroup.com
The pump must only be used in the conditions specified in the technical
data. The pump should be installed away from heat sources and freely ven-
tilated to prevent any accumulation of heat. For outdoor installation, the
pump must be installed in a housing protected from frost in the winter and
sufficiently ventilated in summer. Exposure to direct sunlight must be
avoided.
It is therefore essential to provide protection for persons against contact
with live parts (e.g. electrical connections, motor windings) and moving
parts (e.g. fan). Protection against the entry of foreign bodies must also be
provided.
Pumps have mechanical moving parts that can induce vibrations. To pre-
vent damages at the pump or at peripheral components / facilities as well
as minimizing noise development an appropriate vibration decoupling is
necessary. For this M&C can deliver e.g. anti-vibration pads.
This explicit is also valid for the connection of the sample lines at the pump
head.
MP47 | 1.01.02 15