Introduction; Description; Figure 1 Pump Capacity Mp47 - M&C MP Series Instruction Manual

6

INTRODUCTION

This diaphragm pump MP47 ... is suitable for corrosive gases. It is constructed especially for problems in the anal-
ysis technique.
7

DESCRIPTION

The pump MP47 has a PTFE-head. All sample contacting parts are out of PTFE. The pump works absolutely lubri-
cant free, so gases remain analytically unchanged. Due to a special diaphragm and valve system, the pump oper-
ates maintenance-free.
The MP47 ... is available in 230 V or 115 V and can be equipped with an Ex motor for applications in hazardous
areas as well.
The standard MP47 ... is designed for normal applications at a maximum gas flow of 6 Nl/min. Up to flow rates of
17 Nl/min we recommend the type MP47-Z.
With the option MP .../R a needle valve is build into the pump-head to adjust the flow rate (see data sheet 10.2).
M&C provides for the series MP47 ... pump as option a diaphragm breakage monitoring. MP47 .../D is equipped
with a special double-membrane safety system (see data sheet 10.3).
•
Maximum temperature for medium during operating: -30 to +80 °C [-22 to 176 °C].
•
The pump must be protected from the effects of dust and water.
•
Before use please check the compatibility of the material.
The diaphragm pumps of the series MP47 are not allowed for liquid medium.
Note
450
400
350
300
250
200
150
100
50
0
0,4 0,5 0,6
Figure 1 Pump capacity MP47
8
0,7 0,8 0,9 1
bar abs.
MP47 | 1.01.02
MP47
1,2 1,4 1,6 1,8 2 2,2
www.mc-techgroup.com