Firstech CM6200 Installation Manual page 25

CM6200 Install Guide
*Set the reservation time at 7 am (see User's guide)
**Turn on Timer Mode of the 2 way LCD remotes (see User's Guide)
2-07 Remote Start Runtime - This option give you four different settings for the remote start run time. This
available options are 15, 25,45, and 3 minutes.
2-08 Temperature of Cold Starting – Works in conjunction with Options 2-05 and 2-06. See the option
table for available temperatures.2-09
2-09 Temperature of Hot Starting – Works in conjunction with Options 2-05 and 2-06. See the option
table for available temperatures.
2-10 Engine Sensing – Review the "Common Procedures" section for complete explanations on the four
engine sensing modes.
2-11 Advanced Tachless- This feature when used in conjunction with feature 2-10 option 3 will provide
an enhanced Tachless engine sensing mode.
2-12 Min. Crank Time - This feature applies to feature 2-10 option 3 and 4. It will add or remove crank
time to the default setting of the afore mentioned options 3 and 4.
2-13 Timer Mode - This feature enables the user to operate Timer Mode (see option 2-06). Remember
that the user must still activate Timer mode using the remote (see the user manual for that remote for
instructions).
3-01 Parking Lights while Remote Started - This option changes the parking light behavior during remote
start.
3-02 Confirmation chirps- This feature will allow the user to select a shorter siren output time to simulate
a quieter arm/disarm/start output. (only available with feature 3-06 option 2)
3-03 Dome Light Delay – This feature is used when connecting the door trigger input to the vehicles a
delayed dome light circuit. It delays reading the door trigger input for the selected amount of time
to prevent the door open icon displaying on 2 Way remotes upon lock/arm. Option 4 "auto" will
look for a change in polarity before it starts to monitor the door input (only available with feature
3-06 option 2)
3-04 Starter-Kill – This option determines the mode of the anti-grind/starter-kill relay.
Default 1: Anti-grind + starter-kill
Option 2: Anti-grind only (no starter-kill)
Option 3: Anti-grind + passive starter-kill: starter-kill activates in 45 seconds after ignition is turned
off.
Copyright 2012 Firstech, LLC.
Starter System
www.firstechonline.com | www.compustar.com
Page 25