Firstech CM6200 Installation Manual page 33

CM6200 Install Guide
Troubleshooting
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those two flashes the parking lights will flash again corresponding to the error table below:
Parking Light
*2 Way remotes will display the error number "Strt Er##" on the LCD.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle's parking lights
will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate the
shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Number of
Parking Light
Copyright 2012 Firstech, LLC.
Number of
Flashes
Motor running or must program tach before 1st remote
1
start
2 Key in ignition on position
3 Door open (manual transmission only)
5 Foot brake on
6 Hood open
7 Reservation off (manual transmission only)
8 Tach or tachless sensing failure
9 DAS sensor shutdown
10 System is in Valet Mode
Flashes
1 Lost engine sensing signal (Tach/Alternator/Tachless)
2 Lost emergency brake signal (Manual Transmission)
3 Foot brake triggered
4 Hood pin triggered
Remote Start Error
Remote Start Shutdown Error
Starter System
www.firstechonline.com | www.compustar.com
CM6200
Page 33