Firstech CM6200 Installation Manual page 8

Starter System
www.firstechonline.com | www.compustar.com
CM6200 Install Guide
STEP 4: Once you get two parking light flashes, you are ready to test your DAS.
Testing The DAS Sensor
STEP 1: Turn the ignition off and Arm/Lock the system.
STEP 2: Wait 30 seconds then test the impact sensitivity.
Secure Valet Switch
The optional Secure Valet Switch prevents the alarm from being put into valet mode through cycling the
ignition on/off five times. The Secure Valet Switch is more secure than traditional toggle / valet switches
because it requires a two digit code. To program this feature you must perform the following procedures:
STEP 1: Turn on Option 3-10-III.
STEP 2: Turn ignition key to the "on" position.
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with
successful completion of this step.
STEP 4: Enter the first digit of the desired two-digit pass code by depressing the switch the number of times that
coordinates with the desired first number. For example, to enter 3, depress the switch 3 times, then wait.
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter
your second number by repeating step 4.
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 – 5 to enter your Secure
Valet code.
**The first two digits of the RPS unlock/disarm pass code will be the default pass code for the Secure Valet
(you do not need to program them independently).
Thermister (Temperature Sensor)
Every 2 Way LCD Firstech RF kit includes an optional thermister, which must be plugged into the 2 pin
port of the control module for use. This plug is blue on the CM6200. The use of the thermister allows the
2 Way remote to display the vehicle's interior temperature on the remote LCD (liquid crystal display) as
well as permitting the vehicle to start with timed Hot or Cold starting; see options 2-05, 2-07 and 2-08.
IMPORTANT: Plug is a blue 2 pin connectors on the CM6 series but thermisters with white plugs will work.
Copyright 2012 Firstech, LLC. Page 8