Slide Door Operation - True TDB-24-48-1-G-1-HC Installation Manual

Cabinet Adjustments, Servicing & Component Replacement (cont.)
Fig. 5. Align the left edge of the right door with the left edge of the True logo.
Fig. 7.
Remove the door cord from the roller bracket.
Fig. 9. Be sure the door cord is in the roller slot closest to the pulley.
Slide Door Operation – Door Adjustment
Only adjust the cabinet after it has been installed in its final location
and correctly leveled.
Procedure
1. Completely close the slide doors and check for openings. If
there are any gaps/openings between the closed doors and
cabinet, the doors will need to be adjusted.
2. With a 7/16" wrench or adjustable wrench and 1/8" Allen
wrench, loosen the roller and move it along the slotted hole.
After the adjustment has been made tighten the roller into
place. See fig. 1.
TEC_TM_114 | REV. C | EN
U N D E R B A R R E F R I G E R A T I O N
Fig. 6. Align the right edge of the left door with the right edge of the TRUE logo.
Fig. 8.
Slide the black tab holding the door cord out the back
Fig. 1. Adjust the roller.
03/1/2023
truemfg.com
Page 25 of 28