Tbb/Tdd-1-Hc Pallet Removal - True TDB-24-48-1-G-1-HC Installation Manual

Installation (cont.)

TBB/TDD-1-HC Pallet Removal

Required Tools
Required tools include (but may not be limited to) the following:
• Cutting Tool
• Phillips Screwdriver or Bit Driver
• Drill (optional)
Procedure
1. Remove all interior contents. Cut the banding, and then set the
cardboard aside. See fig. 1.
NOTE: Save the cardboard for step 3.
2. Unscrew the brackets from the pallet. Use drill if desired.
See fig. 2.
3. Place some cardboard on the pallet's edge with the handle,
and then place cardboard on the floor to cushion the unit's
top. See 4b. See figs. 3a and 3b.
4. Ensure the unit's hinges will be on top. Then, tilt the unit off
the pallet and then rest the unit on the cardboard. See figs. 4a
and 4b.
NOTE: Do not let the castors rest on the pallet to keep unit
from moving.
5. Unscrew brackets from unit. See fig. 5.
NOTE: Fig. 5 shows rear bracket; front brackets do not have
a rear metal plate.
Fig. 4a.
Tilt the unit sideways with the hinged side
up. Keep castors from resting on the pallet to prevent
movement.
Page 6 of 28
U N D E R B A R R E F R I G E R A T I O N
Fig. 1.
cardboard.
Fig. 3a.
pallet from scratching the unit.
Fig. 4b.
Use cardboard to protect the unit's top from
damage.
03/1/2023
Remove contents and save the
Use cardboard to keep the
Fig. 5.
Unscrew all brackets from the unit, as the circle
indicates. Arrow indicates rear metal plate.
P#975552
truemfg.com
Fig. 2. Unscrew all brackets from the
pallet.
Fig. 3b. Place the cardboard about 3'
away to cushion the unit's top (see 4b).
TEC_TM_114 | REV. C | EN