Table of Contents
Advertisement
Installation & Setup
Installation & Setup
WARNING!
for performing
The appliance owner is responsible
a Personal Protective Equipment (PPE) hazard
Assessment and to ensure adequate protection during
maintenance and cleaning procedures.
Use appropriate
tools, safety equipment, and PPE
during installation and servicing.
Take care when moving, installing,
Sharp edges!
cleaning, servicing and maintaining the appliance to
avoid cuts. Be sure to take care when reaching under
the appliance or handling metal components. Keep
fingers out of pinch point areas, such as the space
between appliance doors and surrounding appliances.
Take care closing doors with children nearby.
Risk of electrical shock or burn!
Powering off an
electronic control or setting temperature controls to
the 0 (off) position does not remove power from all
components. Unplug the appliance or turn off the
power supply before installation or servicing.
Appliance may pose a tipping hazard
Tip over hazard!
when uncrating, installing or moving the appliance.
Take appropriate safety precautions. Use of tip over
restraints may only reduce (not eliminate) the tipping
hazard. Never allow children to climb or hang on
drawers, doors or shelves.
Crush or cut hazard!
Keep clear when uncrating,
installing, moving, or servicing the appliance.
Page 12 of 36
AIR CURTAIN
Uncrating
USER ACTION!
• If the appliance is damaged, note all damage on
the delivery receipt, immediately file a claim with
he delivery freight carrier, and contact TRUE.
NOT install the appliance or put it in service.
• If the appliance is laid on its back or side, be sure
to leave the appliance upright twice the time it
has been laying down (up to four (4) hours) before
plugging the appliance into a power source. If
this time exceeds four (4) hours, let the appliance
sit upright for 24 hours before powering the
appliance.
NOTICE!
Keys for appliances with door locks are located in the
warranty packet.
Required Tools
Required tools include (but may not be limited to) the following:
• Adjustable wrench
• Phillips screwdriver
12/13/2023
P#975542
TEC_TM_086 | REV. C | EN
truemfg.com
Installation & Setup (cont.)
Procedure
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with the
freight carrier if there is damage.
2. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 2.
NOTICE ›
Move the unit as close as possible to the final
location before removing the wooden skid. Some models may
require removing the front and/or rear grill/cover to access the
shipping bolts.
3. If leveling legs or castors will not be used, remove the cabinet
DO
from the wood skid and set the skid aside.
NOTICE ›
DO NOT lift the cabinet by the countertops,
doors, drawers, or grills.
If leveling legs or castors will be used, rotate the cabinet on
the skid (see fig. 3) and see the installation instructions on
pg. 15.
TEC_TM_086 | REV. C | EN
AIR CURTAIN
Fig. 1. Remove the outer packaging.
Fig. 2. Remove all shipping bolts.
Fig.3. Remove the cabinet from the wood skid and set aside.
12/13/2023
truemfg.com
Page 13 of 36
Advertisement
Table of Contents
