Installation; Uncrating - True TDB-24-48-1-G-1-HC Installation Manual

Installation

Uncrating

Required Tools
Required tools include (but may not be limited to) the following:
• Adjustable wrench
• Phillips screwdriver
• Level
Procedure
1. Remove the outer packaging (cardboard and bubble wrap
or Styrofoam corner and clear plastic). See fig. 1. Inspect for
concealed damage. Again, immediately file a claim with
the freight carrier if there is damage.
NOTE: DO NOT remove the shipping bracket (glass swing
doors; fig. 2) until the unit is installed in its final location.
Do not discard; use the brackets when next moving the
cabinet.
2. If applicable, remove the L-bracket securing the cabinet to the
skid. See fig. 3.
3. With an adjustable wrench, remove all shipping bolts securing
the wood skid to the bottom of the cabinet. See fig. 4.
NOTE: Move the unit as close as possible to the final
location before removing the wooden skid. Some models
may require removing the front and/or rear grill/cover to
access the shipping bolts.
4. If leveling legs or castors will not be used, remove the
cabinet from the wood skid and set the skid aside.
NOTE: DO NOT lift the cabinet by the countertops, doors,
drawers, or grills.
If leveling legs or castors will be used, and need to be
installed, rotate the cabinet on the skid (see fig. 5) and see
the installation instructions on page 7
NOTE: Remember to leave cabinet upright for 24 hours before
plugging into a power source. Keys for cabinet with door locks
are located in the warranty packet.
– Units may pose a tipping hazard
WARNING
while uncrating, during installation, or when
moving the unit.
Fig. 4. Shipping bolt locations.
TEC_TM_114 | REV. C | EN
U N D E R B A R R E F R I G E R A T I O N
Fig. 1. Remove the exterior packaging.
Fig. 2. Remove the glass swing door shipping bracket, if so equipped. Do not
discard.
Fig. 3. If present, remove the L-bracket.
Fig. 5.
When lifting unit, do not use counter tops, doors/drawers, or grills as a lifting
point.
03/1/2023
truemfg.com
Page 5 of 28